With the router powered on, press and hold the RESET button on the back of the router for more than 10 seconds until the system LED starts to flash quickly. Then release the button and wait for the router to reboot to its factory default settings. Preparation. Power up the TP-link router. Connect an ethernet cable between port 1 of the RISE

There are two methods to reset to the Router's factory defaults: Method 1: Hard reset/By pressing the RESET button. With the Router powered on, press and hold the WPS/RESET button (more than 10 seconds) until the SYS LED becomes quick-flash from slow-flash. Then release the button and wait the Router to reboot to its factory default settings.

First, go to your router manufacturer’s support site. Search for your router model and switch to the firmware section. If a new firmware update is available, download the file and extract it. Go to the Firmware section on the Router setup page and click on Choose file. Select the extracted firmware file from Step 3 and press OK. Press and hold the reset pinhole/button with a small object such as a pin for approximately 10 seconds while the router is on. Release the reset button and wait for the device to reboot. The reset pinhole/button can be found using the following images as a guide: 1. Make certain that the router is powered on before it restarts completely. 2. . 401 275 424 93 480 482 41 470

reset tp link router